Krylon QUIK-MARK™ TallBoy™ Water-based Inverted Marking Paints Both APWA and Fluorescent colors are available in water-based and solvent-based formulations, in a variety of sizes. One-coat coverage and our Spray-Thru™ cap allow for inverted painting ease. Use on concrete, pavement, gravel, grass, brick, asphalt, athletic fields, utility, excavation, ground surveying and construction marking.

Features

The TallBoy™ provides 22 oz. of paint (29% more) increasing productivity with Less Trips to the Truck™, fewer cans to dispose and less product to carry.
High-solids formulation for bold, bright, visible markings
Fast-drying formula penetrates and adheres to hot and cold surface
WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. For more information, contact your local health authority. No surface preparation is necessary. Apply directly to desired surface.
After Job Completion: Avoid clogging by turning can right-side up and spray until only clear gas appears. Wipe any paint off spray button opening.
APPLICATION CONDITIONS
For best results use when can is between 70-80 ̊F. Shake can well until mixing ball breaks loose. Hold can at top and swing bottom of can in a circle until ball travels freely (repeat during extended use). To spray, invert can and point spray button 4-6 inches above surface. Press button to the side to actuate. Use with Krylon Marking Wands (K07095 and K07096) to reduce back strain and obtain consistent writing, stenciling and marking. When using marking wands, follow shaking instructions, then insert can and pull trigger to spray
FOR INDUSTRIAL USE ONLY. Thoroughly review product label and SDS for safety and cautions prior to using this product. Please direct any questions or comments to your local Krylon Industrial Representative.